Dlp-B160 Change User And Security Settings - Multiple Nodes; Dlp-B315 Log Out A User - Single Node - Cisco ONS 15327 Procedure Manual

NTP-B205 Modify Users and Change Security

DLP-B160 Change User and Security Settings - Multiple Nodes

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You must add the same user name and password to each node the user will access.
Note
From the View menu, choose Go to Network View. Verify that all the nodes where you want to add users
Step 1
are accessible.
Click the Provisioning > Security > Users tabs. Highlight the user's name whose settings you want to
Step 2
change.
Click Change. The Change User dialog box appears.
Step 3
In the Change User dialog box, enter the following:
Step 4
•
•
•
•
See the
Click OK. A Change Results confirmation dialog box appears.
Step 5
Click OK to acknowledge the changes. Confirm that the changes appear; if not, repeat the task.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-B315 Log Out a User - Single Node

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Active Logins tabs.
Step 1
Choose the user you want to log out and click Logout.
Step 2
Cisco ONS 15327 Procedure Guide, R4.0
9-20
This task changes settings for an existing user on multiple nodes.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Superuser
New Password
Confirm New Password
Security Level
You can also lock out the user by selecting the check box.
"DLP-B75 Create a New User - Multiple Nodes" task on page 3-4
Use this task to log out a user from a single node.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Superuser
Chapter 9 Change Node Settings
for field descriptions.
March 2003