Ntp-B126 Create A Blsr - Cisco ONS 15327 Procedure Manual

Chapter 4 Turn Up Network
Complete the
Step 5
Stop. You have completed this procedure.

NTP-B126 Create a BLSR

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into an ONS 15327 node on the network where you will create the BLSR. See the
Step 1
into CTC" task on page 2-23
From the View menu choose Go to Network View.
Step 2
Step 3 Click the Provisioning > BLSR tabs.
Step 4 Click Create BLSR.
On the BLSR Creation dialog box
Step 5
•
•
•
•
Figure 4-3
March 2003
"NTP-B126 Create a BLSR" procedure on page
This procedure creates a BLSR at each BLSR-provisioned node.
None
NTP-B35 Verify Node Turn Up, page 4-2
NTP-B40 Provision BLSR Nodes, page 4-14
Required
Onsite or remote
Provisioning or higher
for instructions. If you are already logged in, continue with Step 2.
Ring Type—Choose the BLSR ring type, either two-fiber or four-fiber.
Speed—Choose the BLSR ring speed: OC-12 or OC-48. The speed must match the OC-N speed of
the BLSR trunk (span) cards.
Ring ID—Assign a ring ID (a number between 0 and 9999).
Reversion time—Set the amount of time that will pass before the traffic reverts to the original
working path following a ring switch. The default is 5 minutes. Ring reversions can be set to Never.
Setting BLSR Properties
(Figure 4-3), set the BLSR properties:
Cisco ONS 15327 Procedure Guide, R4.0
NTP-B126 Create a BLSR
4-15.
"DLP-B60 Log
4-15