Dlp-B208 Provision A Ds-3 Circuit Source And Destination - Cisco ONS 15327 Procedure Manual

NTP-B186 Create a Unidirectional DS-3 Circuit with Multiple Drops

DLP-B208 Provision a DS-3 Circuit Source and Destination

Purpose
Tools/Equipment
Prerequisite Procedures You perform this task during one of the following procedures:
Required/As Needed
Onsite/Remote
Security Level
After you have selected the circuit properties in the Circuit Source dialog box according to the specific
Note
circuit creation procedure, you are ready to provision the circuit source.
From the Node drop-down menu choose the node where the source will originate.
Step 1
From the Slot drop-down menu choose the slot containing the XTC card where the circuit will originate
Step 2
From the Port drop-down menu choose the source XTC card as appropriate.
Step 3
Step 4 If you need to create a secondary source, for example, a path protection bridge/selector circuit entry
point in a multivendor path protection, click Use Secondary Source and repeat Steps
define the secondary source. If you do not need to create a secondary source, continue with
Click Next.
Step 5
From the Node drop-down menu choose the destination (termination) node.
Step 6
Step 7 From the Slot drop-down menu choose the slot containing the destination card. The destination is
typically a XTC card. You can also choose an OC-N card to the map DS-3 circuit to an STS.
Step 8 Depending on the destination card, choose the destination port or STS from the sub-menus that display
based on the card selected in Step 3. See
display ports, STSs, VTs, or DS1s if they are already in use by other circuits. If you and a user working
on the same network choose the same port, STS, VT, port, or DS1 simultaneously, one of you will receive
a Path in Use error and be unable to complete the circuit. The user with the incomplete circuit needs to
choose new destination parameters.
If you need to create a secondary destination, for example, a path protection bridge/selector circuit exit
Step 9
point in a multivendor path protection, click Use Secondary Destination and repeat Steps
define the secondary destination.
Click Next.
Step 10
Return to your originating procedure (NTP).
Step 11
Cisco ONS 15327 Procedure Guide, R4.0
5-28
This task provisions an electrical circuit source and destination for a DS-3
circuit.
None
NTP-B184 Create an Automatically Routed DS-3 Circuit, page
NTP-B185 Create a Manually Routed DS-3 Circuit, page
NTP-B186 Create a Unidirectional DS-3 Circuit with Multiple Drops, page
5-24
As needed
Onsite or remote
Provisioning or higher
Table 5-2 on page 5-3
Chapter 5 Create Circuits and VT Tunnels
5-22, or
1 through
for a list of valid options. CTC does not
5-18, or
3 to
Step 5.
6 and 7 to
March 2003