Dlp-B298 Check The Network For Alarms And Conditions - Cisco ONS 15327 Procedure Manual

Chapter 12 Convert Network Configurations
Display the new node in node view.
Step 13
Complete the
Step 14
using line timing, set the working OC-N card as the timing source.
Display the network view to verify that the newly created linear ADM configuration is correct. Two
Step 15
green span lines should appear between each linear node.
Click the Alarms tab. Verify that no unexpected alarms are displayed. Ensure that the alarm filter is not
Step 16
turned on.
Repeat the procedure to add an additional node to the linear ADM.
Step 17
Stop. You have completed this procedure.

DLP-B298 Check the Network for Alarms and Conditions

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View. Verify that all affected spans on the network map
Step 1
are green.
Verify that the affected spans do not have active switches on the network map. Span ring switches are
Step 2
graphically displayed on the span with the letters "L" for lockout ring, "F" for FORCE ring, "M" for
MANUAL ring, and "E" for EXERCISE ring.
A second verification method can be performed from the Conditions tab. Click Retrieve Conditions and
Step 3
verify that no switches are active. Make sure the Filter button is not selected.
Click the Alarms tab. Verify that no critical or major alarms are present, nor any facility alarms, such as
Step 4
LOS, LOF, AIS-L, AIS-P, SF, and SD. Make sure the Filter button is not selected.
If trouble is indicated (for example, a major alarm exists), resolve the problem before proceeding. See
Chapter 6, "Manage Alarms,"
Return to your originating procedure (NTP).
Step 5
March 2003
"NTP-B28 Set Up Timing" procedure on page 3-16
This task verifies that no alarms or conditions exist on the network.
None
DLP-B60 Log into CTC, page 2-23
As needed
Remote
Retrieve or higher
or, if necessary, refer to the Cisco ONS 15327 Troubleshooting Guide.
NTP-B154 Convert a Point-to-Point to a Linear ADM
for the new node. If the new node is
Cisco ONS 15327 Procedure Guide, R4.0
12-3