Dlp-B99 Determine Available Vlans - Cisco ONS 15327 Procedure Manual

NTP-B145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect

DLP-B99 Determine Available VLANs

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At any CTC view, click the Circuits tab.
Step 1
Click any existing Ethernet circuit to highlight that row.
Step 2
Step 3 Click Edit, then click the VLANs tab.
The Edit Circuit dialog displays the number of VLANs used by circuits and the total number of VLANs
available for use.
Step 4 Determine that number of available VLANs listed is sufficient for the number of E-series Ethernet
circuits that you will create.
Multiple E-series Ethernet circuits with spanning tree enabled will block each other if the circuits
Caution
traverse the same E-series Ethernet card and use the same VLAN.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15327 Procedure Guide, R4.0
5-68
This task verifies that the network has the capacity to support the additional
new VLANs required for the creation E-Series circuits. It does not apply
to E-Series cards in port-mapped mode.
E-Series Ethernet cards must be installed at each end of the Ethernet
circuit.
NTP-B127 Verify Network Turn Up, page 5-3
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Chapter 5 Create Circuits and VT Tunnels
March 2003