Cisco ONS 15327 Procedure Manual page 29

Install Hardware
The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
Note
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter provides procedures for installing the Cisco ONS 15327 shelf, cards, and fiber-optic cable.
To view a summary of the tools and equipment required for installation, see the
Equipment" section on page
Before You Begin
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
March 2003
1-2.
NTP-B1 Unpack and Inspect the ONS 15327 Shelf Assembly, page
before continuing with the
NTP-B2 Install the Shelf Assembly, page
assembly in a rack before continuing with the
procedure on page 1-11.
NTP-B216 Install the Mechanical Interface Cards, page
the Mechanical Interface cards (MICs) before continuing with the
Ground" procedure on page
NTP-B6 Install the Power and Ground, page
the "NTP-B7 Install the Fan-Tray Assembly" procedure on page
NTP-B7 Install the Fan-Tray Assembly, page
assembly in the shelf before continuing with the
page 1-21.
NTP-B217 Install the XTCs, page
Timing and Control (XTC) cards.
NTP-B218 Install the Optical and Ethernet Cards, page
to install optical and Ethernet cards.
NTP-B219 Remove and Replace a Card, page
and replace an ONS 15327 card.
"NTP-B2 Install the Shelf Assembly" procedure on page
1-5—Complete this procedure to install the shelf
"NTP-B216 Install the Mechanical Interface Cards"
1-12.
1-12—Complete this procedure before continuing with
1-20—Complete this procedure to install the fan-tray
"NTP-B217 Install the XTCs" procedure on
1-21—Complete this procedure to install the Cross-Connect
1-25—As needed, complete this procedure to remove
C H A P T E R
"Required Tools and
1-4—Complete this procedure
1-11—Complete this procedure to install
"NTP-B6 Install the Power and
1-20.
1-23—As needed, complete this procedure
Cisco ONS 15327 Procedure Guide, R4.0
1
1-5.
1-1