Figure 6-15 Alarm Filter Dialog Box Conditions Tab - Cisco ONS 15327 Procedure Manual

Chapter 6 Manage Alarms
In the Time area, check the Show alarms between time limits check box to enable it. Then click the up
Step 4
and down arrows in the From Date, To Date, and Time fields to modify the time limits.
To modify filter parameters for conditions, continue with
continue with
Click the Conditions tab
Step 5

Figure 6-15 Alarm Filter Dialog Box Conditions Tab

When alarm filtering is enabled, conditions in the Show list are visible and conditions in the Hide list
are invisible.
To move conditions individually from the Show list to the Hide list, click the > button.
•
To move conditions individually from the Hide list to the Show list, click the < button.
•
To move conditions collectively from the Show list to the Hide list, click the >> button.
•
To move conditions collectively from the Hide list to the Show list, click the << button.
•
Note
Click Apply and OK.
Step 6
Alarm and condition filtering parameters are enforced when alarm filtering is enabled (see the
"DLP-B225 Enable Alarm Filtering" task on page
disabled (see the
Return to your originating procedure (NTP).
Step 7
November 2004
Step 6.
(Figure 6-15).
Conditions include alarms.
"DLP-B227 Disable Alarm Filtering" task on page
NTP-B168 Enable, Modify, or Disable Alarm Severity Filtering
Step 5. If you do not need to modify them,
6-27), and are not enforced when alarm filtering is
6-30).
Cisco ONS 15327 Procedure Guide, R4.0
6-29