Ntp-B112 Clean Fiber Connectors - Cisco ONS 15327 Procedure Manual

NTP-B112 Clean Fiber Connectors

If needed, recreate the circuits recorded in
Step 12
specific circuit creation procedures.
Stop. You have completed this procedure.
NTP-B112 Clean Fiber Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
Warning
not stare into the beam or view directly with optical instruments.
Using an inspection microscope, inspect each fiber connector for dirt, cracks, or scratches.
Step 1
Replace any damaged fiber connectors.
Step 2
Note
Step 3 Complete the
Wipes" task on page 14-21
Step 4 Complete the
Complete the
Step 5
Caution Do not reuse the optical swabs. Keep unused swabs off of work surfaces.
Stop. You have completed this procedure.
Cisco ONS 15327 Procedure Guide, R4.0
14-20
This procedure cleans the fiber connectors.
Inspection microscope
Compressed air/duster
Type A Fiber Optic Connector Cleaner (CLETOP reel)
Isopropyl alcohol 70 percent or higher
Optical swab
Optical receiver cleaning stick
None
Required
Onsite
Maintenance
Replace all dust caps whenever the equipment will not be immediately used.
"DLP-B 204 Scope and Clean Fiber Connectors and Adapters with Alcohol and Dry
as necessary.
"DLP-B 205 Clean Fiber Connectors with CLETOP" task on page 14-21
"DLP-B 206 Clean the Fiber Adapters" task on page 14-22
Step 3. See Chapter 5, "Create Circuits and VT Tunnels"
Chapter 14 Maintain the Node
as necessary.
as necessary.
March 2003
for