Ntp-B146 Test E-Series Circuits - Cisco ONS 15327 Procedure Manual

NTP-B146 Test E-Series Circuits

NTP-B146 Test E-Series Circuits
Purpose
Tools/Equipment
Prerequisite Procedures This procedure assumes that you completed facility loopback tests to test
Required/As Needed
Onsite/Remote
Security
Complete the
Step 1
already logged in, continue with Step 2.
On the shelf graphic, double-click the circuit source card.
Step 2
Click the Provisioning > Ether Port tabs.
Step 3
Verify the following settings:
Step 4
•
•
•
•
Click the Ether VLAN tab. If the E-Series cards is not in port-mapped mode, verify that the source port
Step 5
is on the same VLAN as the destination port.
Repeat Steps
Step 6
At the destination node, connect the Ethernet test set to the destination port and configure the test set to
Step 7
send and receive the appropriate Ethernet traffic.
Note
At the source node, connect an Ethernet test set to the source port and configure the test set to send and
Step 8
receive the appropriate Ethernet traffic.
Transmit Ethernet frames between both test sets. If you cannot transmit and receive Ethernet traffic
Step 9
between the nodes, repeat Steps
correctly.
Cisco ONS 15327 Procedure Guide, R4.0
5-72
This procedure tests circuits created on E-Series Ethernet cards
provisioned for multicard EtherSwitch Group, single-card EtherSwitch or
port-mapped mode.
Ethernet test set and appropriate fibers
the fibers and cables from the source and destination ONS 15327s to the
fiber distribution panel or the DSX, and one of the following:
NTP-B191 Create an E-Series EtherSwitch Circuit (Multicard or
Single-Card Mode), page 5-53
NTP-B142 Create an E-Series Shared Packet Ring Ethernet Circuit, page
5-57
NTP-B143 Create an E-Series Hub and Spoke Ethernet Configuration,
page 5-60
As needed
Onsite
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
Mode— Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
Enabled—Checked.
Priority—Set to the priority level indicated by the circuit or site plan. Priority does not apply to
E-Series cards in port-mapped mode.
Stp—Checked if Spanning Tree Protocol is enabled for the circuit. STP does not apply to E-Series
cards in port-mapped mode.
1 through 5 for the destination node.
At this point, you will not be able to send and receive Ethernet traffic.
1 through 8 to make sure you configured the Ethernet ports and test set
Chapter 5 Create Circuits and VT Tunnels
at the ONS 15327 source node. If you are
March 2003