Cisco ONS 15327 Procedure Manual page 240

NTP-B147 Create a G-Series Circuit
–
Apply to drop ports—Check this check box if you want to apply the state chosen in the State field
•
(IS or OOS-MT only) to the Ethernet circuit source and destination ports. You cannot apply
OOS-AINS to G-Series Ethernet card ports. CTC will apply the circuit state to the ports only if the
circuit bandwidth is the same as the port bandwidth or, if the port bandwidth is larger than the
circuit, the circuit must be the first circuit to use the drop port. If not, a Warning dialog box displays
the ports where the circuit state could not be applied. If the check box is unchecked, CTC will not
change the state of the source and destination ports.
Note
Create cross-connects only (TL1-like)—Uncheck this check box.
•
Inter-domain (UCP) SLA—If the circuit will travel on a unified control plane (UCP) channel, enter
•
the service level agreement number. Otherwise, leave the field set to zero.
Auto-ranged—Unavailable.
•
Protected Drops—Leave the default unchanged (unchecked).
•
If the circuit will be routed on a path protection, complete the
Step 5
Selectors During Circuit Creation" task on page
Click Next.
Step 6
Provision the circuit source:
Step 7
From the Node drop-down menu choose the circuit source node. Either end node can be the
a.
point-to-point circuit source.
From the Slot drop-down menu choose the slot containing the G-Series card that you will use for
b.
one end of the point-to-point circuit.
From the Port drop-down menu choose a port.
c.
Click Next.
Step 8
Step 9 Provision the circuit destination:
a. From the Node drop-down menu choose the circuit destination node.
From the Slot drop-down menu choose the slot containing the G-Series card that you will use for
b.
other end of the point-to-point circuit.
From the Port drop-down menu choose a port.
c.
Click Next. The Circuits window appears.
Step 10
Confirm that the following circuit information is correct:
Step 11
Circuit name
•
Circuit type
•
Circuit size
•
• ONS 15327 circuit nodes
Step 12 Click Finish.
Cisco ONS 15327 Procedure Guide, R4.0
5-74
OOS-MT—The circuit is in a maintenance state. The maintenance state does not interrupt traffic
flow; it suppresses alarms and conditions and permits loopbacks on the circuit. Use OOS-MT
for circuit testing or to suppress circuit alarms temporarily. Change the state to IS, OOS, or
OOS-AINS when testing is complete. See the
page 8-8.
LOS alarms appear if in service (IS) ports are not receiving signals.
Chapter 5
"DLP-B230 Change a Circuit State" task on
"DLP-B218 Provision Path Protection
5-27.
Create Circuits and VT Tunnels
March 2003