Ntp-B416 Convert A Ctc Circuit To Tl1 Cross-Connects - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 8
Manage Circuits
NTP-B416 Convert a CTC Circuit to TL1 Cross-Connects
Purpose
Tools/Equipment
Prerequisite Procedures Circuits must exist on the network. See
Required/As Needed
Onsite/Remote
Security Level
You can only use this procedure with DS-1, DS-3, or OC-N circuits. You cannot use the procedure with
Note
Ethernet circuits, VT tunnels, or VT aggregation points.
Step 1
Log into an ONS 15327 node on the network where you want to convert the CTC circuits. See the
"DLP-B60 Log into CTC" task on page 2-23
Step 2.
From the View menu choose Go to Network View.
Step 2
Click the Circuits tab and choose the CTC circuit(s) that you want to convert to TL1 cross-connects.
Step 3
The circuit(s) must have an INCOMPLETE or ACTIVE status.
Step 4
From the Tools menu, choose Circuits > Convert CTC Circuit to TL1 Cross-Connects.
Step 5
In the Convert to TL1 Cross Connect dialog box, click OK.
The Convert to TL1 Cross Connect Results dialog box displays the results of the conversion. If any
circuits could not be converted, those circuits are listed.
Step 6
In the Convert to TL1 Cross Connect Results dialog box, click OK.
If the circuit you selected had an INCOMPLETE status, its status will not change. If you selected an
ACTIVE (complete) circuit, its status will change to UPGRADABLE.
If you are repairing a circuit, complete the circuit creation procedure in
Step 7
VT Tunnels,"
On the Circuit Creation wizard, shown in
After you repair or replace all missing cross-connects, CTC automatically merges them and the circuit
status changes to UPGRADEABLE.
March 2003
Use this procedure to convert CTC circuits to a set of TL1 cross-connects,
which enables you to repair a missing cross-connect or change the
cross-connect(s) using the TL1-like circuit option during circuit creation.
None
Tunnels"
for circuit creation procedures.
As needed
Onsite or remote
Provisioning or higher
appropriate to the circuit you are repairing to replace or repair the circuit cross-connects.
NTP-B416 Convert a CTC Circuit to TL1 Cross-Connects
Chapter 5, "Create Circuits and VT
for instructions. If you are already logged in, continue with
Figure
8-3, check Create cross-connects only (TL1-like).
Cisco ONS 15327 Procedure Guide, R4.0
Chapter 5, "Create Circuits and
8-13
Advertisement
Table of Contents
