Dlp-B266 Change Ip Settings - Cisco ONS 15327 Procedure Manual

Chapter 9 Change Node Settings

DLP-B266 Change IP Settings

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Network > General tabs.
Step 1
Step 2 Change any of the following:
•
•
•
•
•
•
See the
Step 3 Click Apply.
If you changed any of the network fields that will cause the node to reboot, the Change Network
Configuration confirmation dialog box appears. If you changed a gateway setting, a confirmation
appropriate to the gateway field appears. If you only changed the IP address fields, no confirmation
dialog box appears.
If a confirmation dialog box appears, click Yes.
Step 4
If you changed an IP address, subnet mask length, or TCC CORBA (IIOP) Listener Port, both XTC cards
will reboot, one at a time. Confirm that the changes appear. If the changes do not appear, repeat the task.
Refer to the Cisco ONS 15327 Troubleshooting Guide, as needed.
Return to your originating procedure (NTP).
Step 5
March 2003
This task changes the IP address, subnet mask, default router, DHCP
access, firewall access, and proxy server settings for the ONS 15327.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Superuser
IP Address
Default Router
Subnet Mask Length
Forward DHCP Request To
TCC CORBA (IIOP) Listener Port
Gateway Settings
"NTP-B169 Set Up CTC Network Access" procedure on page 3-7
NTP-B201 Change CTC Network Access
for detailed field descriptions.
Cisco ONS 15327 Procedure Guide, R4.0
9-5