Cisco ONS 15327 Procedure Manual page 230

NTP-B144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect
Review the VLANs listed in the Available VLANs area. If the VLAN you want to use appears, continue
Step 14
with Step
Click the New VLAN button.
a.
On the New VLAN dialog box, complete the following:
b.
–
–
Click OK.
c.
Click the VLAN you want to use on the Available VLANs column, then click the arrow >> button to
Step 15
move the VLAN to the Circuit VLANs column.
Click Next. The Circuit Creation (Circuit Routing Preferences) dialog box opens.
Step 16
Confirm that the following information about the single-card EtherSwitch manual cross-connect is
Step 17
correct (in this task, "circuit" refers to the Ethernet cross-connect):
Circuit name
•
Circuit type
•
• Circuit size
• VLAN names
ONS 15327 nodes
•
If the information is not correct, click the Back button and repeat the procedure with the correct
information.
Click Finish.
Step 18
Complete the
Step 19
Complete the
Step 20
Stop. You have completed this procedure.
Cisco ONS 15327 Procedure Guide, R4.0
5-64
15. If you need to create a new VLAN, complete the following steps:
VLAN Name—Assign an easily-identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15327 network supports
a maximum of 509 user-provisionable VLANs.
"DLP-B220 Provision E-Series Ethernet Ports" task on page
"DLP-B221 Provision E-Series Ethernet Ports for VLAN Membership" task on page
Chapter 5 Create Circuits and VT Tunnels
5-69.
March 2003
5-70.