Cisco ONS 15327 Procedure Manual page 33

Chapter 1 Install Hardware
To remove the shelf, grasp both sides of the shelf and slowly lift it out of the box.
Step 3
Open the smaller box containing installation materials, and verify that you have all items listed in the
Step 4
"lncluded Materials" section on page
Note
Return to your originating procedure (NTP).
Step 5
DLP-B2 Inspect the Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify the following:
Step 1
•
•
Step 2 If the pins are bent or broken, or the frame is bent, call your Cisco sales engineer for a replacement.
Step 3 Return to your originating procedure (NTP).
NTP-B2 Install the Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
March 2003
The fan-tray assembly is shipped separately.
This task verifies that all parts of the shelf assembly are in good condition.
None
DLP-B1 Unpack and Verify the Shelf Assembly, page 1-4
Required
Onsite
None
Pins are not bent or broken
Frame is not bent
This procedure describes how to reverse the mounting bracket and mount
shelf assemblies in a rack.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Two set screws (48-1003-XX)
NTP-B1 Unpack and Inspect the ONS 15327 Shelf Assembly, page 1-4
Required
Onsite
None
1-2.
Cisco ONS 15327 Procedure Guide, R4.0
NTP-B2 Install the Shelf Assembly
1-5