POINT
POINT
POINT
When changing the network parameter
After writing the network parameter to the C Controller module (Q Series), either turn the C
Controller module (Q Series) OFF and then ON or reset it.
(b)
Routing parameter setting
Up to 64 [Transfer Network No.]s can be set.
However, the same transfer network number cannot be set twice or more (multiple times).
Therefore, the one that can access to other station from the request source host GOT is 64 kinds of [Transfer
Network No.]s.
Transfer target network No.
Relay network No.
Relay station No.
POINT
POINT
POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the request source GOT.
For the setting, refer to the following.
Item
➠
9.3.3 Routing parameter setting
9.4 PLC side setting when connecting to MELSECNET/H
Range
1 to 239
1 to 239
0 to 120
9
9 - 25