Mitsubishi Electric GOT2000 Series Connection Manual page 784

Item
Parity
Retry
Timeout Time
Host Address
Delay Time
Negotiation Time
Initialization Wait Time
Automatioc Negotiation
14 - 28
14.2 System Configuration
Specify whether or not to perform a parity check, and how it is performed
during communication.
(Default: Odd)
Set the number of retries to be performed when a communication timeout
occurs.
(Default: 0time)
Set the time period for a communication to time out.
(Default: 3sec)
Specify the station number of the inverter in the system configuration.
(Default: 0)
Set this item to adjust the transmission timing of the communication
request from the GOT.
(Default: 10ms)
Set the time period that the GOT side communication setting is sent to the
inverter.
(Default: 5sec)
Set the wait time from when the communication setting is changed until
when the communication starts.
(Default: 3sec)
Set whether to use the automatic connection.
(Default: Yes)
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication
Settings] after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manuals.
➠
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
POINT POINT POINT
Cutting the portion of multiple connection of the controller
By setting GOT internal device, GOT can cut the portion of multiple connection of the controller.
For example, faulty station that has communication timeout can be cut from the system.
For details of the setting contents of GOT internal device, refer to the following manual.
➠
GT Designer3 (GOT2000) Screen Design Manual
Description Range
Odd
0 to 5times
1 to 30sec
0 to 31
0 to 300ms
1 to 10sec
1 to 10sec
Yes
No