Connecting Serial Communication Module (Q, L Series) - Mitsubishi Electric GOT2000 Series Connection Manual

7.5.2

Connecting serial communication module (Q, L Series)

■1. [Intelligent function module switch setting] on GX Developer
[The intelligent function module switch setting] on GX Developer is not necessary. (When no [intelligent function
module switch setting] is made, the module runs in the GX Developer connection mode.)
A module can be also connected to a GOT by making the following [intelligent function module switch setting] on GX
Developer.
(1) When connecting to the CH1 side
Switch
No.
Switch 1
Switch 2
Switch 5
7 - 36
7.5 PLC Side Setting
POINT POINT POINT
(1) Serial communication module (Q, L Series)
For details of the serial communication module (Q, L Series), refer to the following manual.
➠
Q Corresponding Serial Communication Module User's Manual (Basic)
➠
MELSEC-L Serial Communication Module User's Manual (Basic)
(2) Modem interface module
For details of the modem interface module, refer to the following manual.
➠
Modem Interface Module User's Manual
Bit
Position Specified value
b0 OFF
b1 OFF
b2 OFF
b3 OFF
b4 OFF
b5 OFF
b6 OFF
b7 OFF
b8 to b15 ―
―
―
Description
Operation setting
Data Bit
Parity Bit
CH1
Even/Odd parity
transmission
Stop bit
*1
settings
Sum check code
Write during RUN
Setting modifica-tions
*2
CH1 transmission speed setting
CH1 Communication protocol setting
Station number setting
Set value
(Operates according to
the GOT side 0000H
specifications.)
GX Developer
0000H
connection
0th station 0000H
*3