Ethernet Connection - Mitsubishi Electric GOT2000 Series Connection Manual

Graphic operation terminal

Hide thumbs Also See for GOT2000 Series:

Table of Contents

Ethernet connection

■1. Via network system

GOT with Ethernet communication cannot access the CNCs in another network via the CNC (network module,

Ethernet module, etc.).

■2. When connecting to multiple GOTs

When connecting two or more GOTs in the Ethernet network, set each [PLC No.] to the GOT.

■3. When connecting to the multiple network equipment (including GOT) in a segment

By increasing the network load, the transmission speed between the GOT and CNC may be reduced.

The following actions may improve the communication performance.

• Using a switching hub

• More high speed by 100BASE-TX (100Mbps)

• Reduction of the monitoring points on GOT

■4. Ethernet cable connection

Ethernet cable is so susceptible to noise that you should wire power cables and electric supply cables separately. And

you need to attach a ferrite core (attachment) on the control unit side.

For details of the Ethernet cable connection, refer to the following

■5. Version of CNC

For MELDAS C6/C64, use NC system software version D0 or later.

17.7 Precautions

17.4.1 Setting communication interface (Controller Setting)

C6/C64/C64T NETWORK INSTRUCTION MANUAL BNP-B2373 IX Connection Function with

FG cable for Ethernet

Ferrite core

Show Quick Links

Table of Contents