Mitsubishi Electric GOT2000 Series Connection Manual page 817

For the details of the inverter parameters, refer to the following.
➠
Manual of the inverter used
(3) Alarm definition
A0
A1
A2
A3
A4
A5
A6
A7
*1 Only reading is possible for A0 to A7.
These devices cannot be used for a write object (numerical input etc.).
(4) Parameter
The numbers of virtual devices for inverter (parameter (Pr)), used by GOT, correspond to the inverter parameter
numbers.
For the inverter parameters, refer to the following.
➠
Manual of the inverter being used
POINT POINT POINT
(1) Monitoring Pr.37
(2) When setting "8888" or "9999" to inverter parameter (Pr)
(3) Precautions for setting calibration parameter (Pr900 to Pr905)
*1
Device name
GOT cannot monitor the parameter (Pr.37) of FREQROL-E500/S500(E)/F500J/D700/
F700PJ/E700.
"8888" and "9999" designate special function.
To set these numbers from GOT, designate a number as shown below.
Set value of inverter side
8888
9999
When setting a calibration parameter (Pr900 to Pr905), it is necessary to set the value below
for extension second parameter (SP108), depending on the device number to be used and
the inverter model.
Value to be set to extension second parameter (SP108)
H00
H01
H02
Description
Second alarm in past
Latest alarm
Fourth alarm in past
Third alarm in past
Sixth alarm in past
Fifth alarm in past
Eighth alarm in past
Seventh alarm in past
Value specified by GOT
Analog value at terminal
14.4 Device Range that Can Be Set
65520
65535
Description
Offset/gain
Analog
14 - 61
14