Mitsubishi Electric GOT2000 Series Connection Manual page 660

(b) Link refresh setting
Special relay (SB) refresh device
Special register (SW) refresh device
Remote input (RX) refresh device
Remote output (RY) refresh device
Remote register (RWr) refresh device
(c) CC-Link configuration setting
Station type
Exclusive station count
Reserve/invalid station select
Intelligent buffer select (word)
*1
*2
12 - 18
12.4 PLC Side Setting
Item
*1
Item
*2
When the [Mode] of the CC-Link module is set at [Remote net - (Ver. 1 mode)], [Remote station points] cannot be set.
Set the same setting as that of the GOT.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
Set value
-
-
Set as necessary.
: Necessary
Set value
Intelligent device station (fixed)
Exclusive station 1
No setting
(Use default value)
: Necessary
Setting necessity at GOT
connection
: As necessary : Not necessary
Setting necessity at GOT
connection
: As necessary : Not necessary