Mitsubishi Electric GOT2000 Series Connection Manual page 715

(b) Station Information Setting
• Station information setting of station No.1 (GOT)
Item
Station Type
Number of Occupied Stations
Reserve/Invalid Station Select
• Station information setting of station No.4 (GOT)
Item
Station Type
Expanded Cyclic Setting
Number of Occupied Stations
Reserve/Invalid Station Select
*1 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU either turning OFF
and then ON or resetting.
POINT POINT POINT
Connecting to MELSEC iQ-F Series
When connecting with MELSEC iQ-F series, it isn't possible to establish a network parameter in
GX Works3. Set the network parameters in the sequence program. Refer to the following.
(2) Setting from sequence program
The parameter is written to the buffer memory, and the data link is automatically started when PLC CPU status
changes from STOP to RUN.
(a) I/O signal of CC-Link module
➠ FX3U-16CCL-M USER'S MANUAL
(b) Devices used by user
Device
D0
D1
D2
D3
D4
D5
D6
D20
D21
Ver.1 Intelligent Device Station (fixed)
*1
Ver.2 Intelligent Device Station (fixed)
*1
*1
➠
(2)Setting from sequence program
Mode
Number of connected modules
Retry Count
Automatic Reconnection Station Count
PLC Down Select
Data Link Disorder Station Setting
Case of CPU STOP Setting
Station information (1st unit)
Station information (2nd unit)
Set value
Occupied Station 3
No Setting
: Necessary
Set value
Quadruple
Occupied Station 1
No Setting
: Necessary
Application
12.4 PLC Side Setting
Setting necessity at GOT connection
○
○
○
: As necessary : Not necessary
Setting necessity at GOT connection
○
○
○
○
: As necessary : Not necessary
12 - 73
12