Connection To C Controller Module (Melsec Iq-R Series) - Mitsubishi Electric GOT2000 Series Connection Manual

12.4.4

Connection to C Controller module (MELSEC iQ-R Series)

This section describes the settings of the GOT and C Controller module (MELSEC iQ-R Series) in the following case of
system configuration.
Use CW Configurator for the C Controller module (MELSEC iQ-R Series) communication settings.
■1. System configuration
*1
■2. Module parameter setting of CW Configurator
(1) [Module parameter] of CW Configurator
(a) Module parameter
Station type
Mode
Station No.
Transmission speed
Channel No.
*1
12 - 26
12.4 PLC Side Setting
POINT POINT POINT
CC-Link module (MELSEC iQ-R Series)
For details of the CC-Link module (MELSEC iQ-R Series), refer to the following manual.
➠ Manuals of MELSEC iQ-R Series
*1
<CC-Link module>
(Use the default value for settings other than the following.)
Type
Station No.
Mode Setting
All connect count
Transmission speed
The CC-Link module is mounted on the base unit slot 0.
The Start I/O No. of the CC-Link module is set to "0".
Item
*1
Adjust the settings with GOT settings.
<GOT(Ver.1 compatible)>
(Use the default value for
settings other than the following.)
Station type : Intelligent
device station
Station No. : Station No.1
:
Number of
stations occupied
Transmission speed
<GOT(Ver.2 compatible)>
(Use the default value for
settings other than the following.)
Station type
Station No.
Expanded cyclic
setting
Number of
stations occupied
Transmission speed :
: Master station
: Station No.0
: Remote net (Ver.2 mode)
: 2
: 156kbps
Set value
Master station
Remote net (Ver.2 mode)
0 (fixed)
156kbps
(Use default value)
Exclusive station 1
156kbps
:
: Intelligent
device station
: Station No.2
: Single
:
Exclusive
station 1
156kbps
Setting necessity at GOT connection
: Necessary : As necessary : Not necessary