Connecting To Melsec-Q/L Series - Mitsubishi Electric GOT2000 Series Connection Manual

■3. GT Designer3 [Communication settings] of System configuration (Network Type: CC IE
Field)
Network Type
Network No.
Station No.
Group No.
Mode Setting
Refresh Interval
Input for Err. Sta.
Retry
Timeout Time
Delay Time
Monitor Speed
11.4.3

Connecting to MELSEC-Q/L series

■1. System configuration (Network Type: CC IE Field)
*1 The CC-Link IE Field Network module is mounted on slot 0 of the base unit.
The start I/O No. of the CC-Link IE Field Network module is set at [0].
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the request source GOT.
For the setting, refer to the following.
➠ 11.3.3 Routing parameter setting
Item
POINT POINT POINT
[Controller Setting] of GT Designer3
For the setting method of [Controller Setting] of GT Designer3, refer to the following.
➠
11.3.1 Setting communication interface (Controller Setting)
CC-Link IE Field Network
<CC-Link IE Field Network module> *
(Use the default value for settings other than the following.)
Station No.
Mode
Network type
Network No.
Total stations
Network Configuration Settings :
POINT POINT POINT
When connecting to Q170MCPU or Q170MSCPU(-S1)
When connected to Q170MCPU or Q170MSCPU(-S1), the start I/O No. of the CC-Link IE Field
Network communication unit is set to "70".
25ms (Use default value)
Clear (Use default value)
3times (Use default value)
3sec (Use default value)
0ms (Use default value)
High (Normal) (Use default value)
<GOT>
(Use the default value for settings other
than the following.)
RX/RY00 to FFH
RW RW 00 to FFH
W/ r
1
: 0 (fixed)
: Online (normal)
: CC IE Field (Master station)
: 1
: 1
RX/RY00 to FFH
H
RW RW 00 to FFH
W/ r H
11.4 PLC Side Setting
Set value
CC IE Field
1: Network No.1
1: Station No.1
0 (fixed)
Online
11 - 19
11