Mitsubishi Electric GOT2000 Series Connection Manual page 781

(5) Terminal block layout in the FR-E7TR control terminal option
Mount the FR-E7TR to the E700 series and the sensorless servo (FREQROL-E700EX series).
■3. Connecting terminating resistors
(1) GOT side
When connecting a PLC to the GOT, a terminating resistor must be connected to the GOT.Set the terminating
resistor setting switch.
For the procedure to set the terminating resistor, refer to the following.
➠ 1.4.3 Terminating resistors of GOT
Set the terminal 2/SG switch to the
OPEN OPEN
right position (ON) to change the
terminal 2 to the terminal SG.
100 100
To the GOT or
10 4
the previous
inverter
SDA SDB RDA RDB SG SDA SDB RDA RDB SG 2 2
SDA SDB RDA RDB RUN FU
SDA SDB RDA RDB RUN FU
FM RL
A B C
O
N
SE SE
RM RH MRS RES SD PC STF STR SD SD
To the next inverter
14.2 System Configuration
14
14 - 25