Device Range That Can Be Set - Mitsubishi Electric GOT2000 Series Connection Manual

15.6 Device Range that Can Be Set

The device ranges of controller that can be used for GOT are as follows.
Note that the device ranges in the following tables are the maximum values that can be set in GT Designer3.
The device specifications of controllers may differ depending on the models, even though belonging to the same series.
Please make the setting according to the specifications of the controller actually used.
When a non-existent device or a device number outside the range is set, other objects with correct device settings may not
be monitored.
15.6.1 When directly connecting the GOT to a servo amplifier
■1. Device settings
Item
Set the device name, device number, and bit number.
Device
The bit number can be set only when specifying the bit of word device.
Information Displays the device type and setting range which are selected in [Device].
Set the monitor target of the set device.
All
Network
Selection
Switch to the Clicking the button displays the dialog box indicating the correspondence between the GOT virtual device for a servo amplifier
device define and the definition of servo amplifier.
dialog If selecting an item on the displayed dialog box, remember that the servo amplifier definition is displayed in the text box below.
*1
15 - 26
15.6 Device Range that Can Be Set
Select this item when writing data to all servo amplifiers connected.
During a monitoring, the servo amplifier of Station No. 0 is monitored.
When inputting data by Numerical Input, the data is written to all servo amplifiers connected during
inputting; the servo amplifier of Station No. 0 is monitored during other than inputting (displaying).
Select this item when monitoring the servo amplifier of the Station No. specified.
After selecting, set station numbers of servo amplifiers in the following range.
0 to 31:
The servo amplifier of the Station No. specified will be monitored.
100 to 115:
Specify the Station No. of the servo amplifier to be monitored with a GOT data register (GD).
Refer to the following.
Station No.
100
101
:
114
115
Description
GOT data register (GD)
GD10
GD11
:
GD24
GD25
*1
Setting range
0 to 31
(If setting a value out of the range above,
a timeout error occurs.)