Mitsubishi Electric GOT2000 Series Connection Manual page 634

(b) Network Configuration Settings
Rx/RY, RWw/RWr
*1
setting(1)
Reserved/Error Invalid Station
*1
(c) Routing setting
Up to 238 [Target Station Network No.]s can be set.
However, the same target station network number cannot be set twice or more (multiple times).
Therefore, the one that can access to other station from the request source host GOT is 238 kinds of [Target
Station Network No.]s.
Target Station network No.
Relay Station network No.
Relay Station No.
11 - 18
11.4 PLC Side Setting
Item
Rx/RY setting
RWw/RWr setting
Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
(1) When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON
again, or reset the PLC CPU.
(2) GOT station type
Set the GOT as an intelligent device station.
Item
Start
Station No.1
End
Start
Station No.1
End
: Necessary
1 to 239
1 to 239
0 to 120
Set value Setting necessity at GOT connection
0000H
00FFH
00000H
00007H
No setting
: As necessary
Range
: Not necessary