Connecting To Cc-Link Module (Melsec Iq-R Series) With Ver.2 Compatible - Mitsubishi Electric GOT2000 Series Connection Manual

12.4.2 Connecting to CC-Link module (MELSEC iQ-R Series) with Ver.2
compatible
This section describes the settings of the GOT and the CC-Link module (MELSEC iQ-R Series) with Ver.2 compatible in the
following system configuration.
■1. System configuration
*1
■2. Module parameter setting of GX Works3
(1) [Module parameter] of GX Works3
(a) Module parameter
Station type
Mode
Station No.
Transmission speed
Parameter setting
*1
12 - 20
12.4 PLC Side Setting
POINT POINT POINT
CC-Link module (MELSEC iQ-R Series)
For details of the CC-Link module (MELSEC iQ-R Series), refer to the following manual.
➠
Manuals of MELSEC iQ-R Series
*1 (Use the default value for
<CC-Link module>
settings other than the following.)
Type : Master station
Station No. : Station No.0
Mode : Remote net (Ver.2 mode)
All connect count : 1
Transmission speed : 156kbps
The CC-Link module is mounted on the base unit slot 0.
The Start I/O No. of the CC-Link module is set to "0".
Item
*1
Adjust the settings with GOT settings.
<GOT>(Use the default value for
settings other than the following.)
Station type : Intelligent device station
Station No. : Station No.1
Expanded cyclic setting : Single
:
Number of Exclusive station 1
stations occupied
Transmission speed 156kbps
:
Set value
Master station
Remote net
(Ver.2 mode)
0 (fixed)
156kbps
Parameter
: Necessary
Setting necessity at GOT
connection
: As necessary : Not necessary