Mitsubishi Electric GOT2000 Series Connection Manual page 350

Router relay parameter
E-mail settings
*1 Set the number of the Ethernet module.
(2) Operational settings
Communication date code
IP address
Initial timing
Send frame setting
TCP Existence confirmation setting
*1 Because the port No. 5551 is fixed, the GOT operates as follows, regardless of the setting for the item.
• Communication date code : [Binary code]
• Initial timing : [Always wait for OPEN]
*2 The default value of IP address is 192.168.1.254. Set the IP address corresponding to the system configuration.
5 - 84
5.4 PLC Side Setting
Item
Item
*1
*1
(Communications are enabled while the programmable controller CPU stops.)
POINT POINT POINT
When changing Ethernet parameter
After writing the Ethernet parameter to the programmable controller CPU, turn off and then on, or
reset the programmable controller CPU.
Setting
(Use default value.)
:Required
Setting
(Use default value.)
192.168.3.19
(Use default value.)
:Required
Setting
(with GOT connected)
:Set if necessary :Not required
Setting
(with GOT connected)
:Set if necessary :Not required