Connection To C Controller Module (Melsec Iq-R Series) - Mitsubishi Electric GOT2000 Series Connection Manual

11.4.2

Connection to C Controller module (MELSEC iQ-R Series)

This section describes the settings of the GOT and C Controller module (MELSEC iQ-R Series) in the following case of
system configuration.
Use CW Configurator for the C Controller module (MELSEC iQ-R Series) communication settings.
■1. System configuration (Network Type: CC IE Field)
*1 The CC-Link IE Field Network module is mounted on slot 0 of the base unit.
The Start I/O No. of the CC-Link IE Field Network module is set at "0".
■2. Module parameter settings of System configuration (Network Type: CC IE Field)
(1) [Module parameter] of CW Configurator
(a) Module parameter
Station type
*1
Network No.
Station No.
Parameter setting
Channel No.
Network Configuration Settings
*1 Specify the same network No. as that of the GOT.
<GOT>
(Use the default value for settings other than
the following.)
CC-Link IE Field Network
<CC-Link IE Field Network module>
(Use the default value for settings other than the following.)
Station No.
Mode Setting
Network type
Network No.
Total stations
Network Configuration Settings :RX/RY00
Item
*1
:0 (fixed)
:Online (normal)
:CC IE Field (Master station)
:1
:1
to FFH
H
RW RW 00 to FFH
W/ r H
Set value
Master station (fixed)
1
0 (fixed)
Parameter
(Use default value)
Refer to (b)
: Necessary : As necessary
11.4 PLC Side Setting
11
Setting necessity at GOT
connection
: Not necessary
11 - 17