Mitsubishi Electric GOT2000 Series Connection Manual page 319

Item
Default router IP address
Communication data code
Enable online change (FTP, MC protocol)
Disable direct connection to MELSOFT
Do not respond to search for CPU (Built-in
Ethernet port) on network
Open settings
FTP settings
Time settings
MELSOFT Connection Extended Setting
(b) Open settings
The setting is required for all the connected GOTs.
Protocol
Open system
(2) [Controller Setting] and [Ethernet] of GT Designer3
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
(2) Ethernet setting
(a) Controller setting
GOT Net No.
GOT Station
GOT Standard Ethernet Setting
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
➠
(b) Open settings
Item
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠ 5.3.1 Setting communication interface (Controller Setting)
When connecting Built-in Ethernet port QCPU or LCPU to a GOT, the settings items for the
network No. and station No. do not exist at the PLC side. However, these virtual values must
be set on the GOT side. Therefore, set the network No. and station No.
Therefore, set the network No. and station No.
Set the network No. that is not existed on the network system and any station No..
Item
Set value
-
(Use default value)
(Use default value)
○: Necessary
MELSOFT connection
Set value (Use default value)
192.168.3.18
5.4 PLC Side Setting
Setting necessity at GOT connection
×




○



: As necessary ×: Not necessary

Set value
UDP
1
1
5001
3times
3sec
3sec
0ms
5 - 53
5