Setting For Communication Settings - Mitsubishi Electric GOT2000 Series Connection Manual

21.3.5

Setting for communication settings

Make communication settings based on the interface and the installation position of the respective communication units.
3rd stage
2nd stage
1st stage
(Example: For GT27)
Check
Extend interface
Standard interface 4
(Ethernet interface
built in the GOT)
Standard interface 1
(RS-232 interface
built in the GOT)
Standard interface 3
(RS-422/485 interface
built in the GOT)
Standard interface 2
(USB interface built in the GOT)
Make settings for Communication Settings by GT Designer3 referring to the check sheet
where the necessary information has been written.
The positions that the settings should be made on the communication settings screen are
specified on the check sheet by numbers.
3rd stage
2nd stage
1st stage
(Example: For GT27)
(7)
(8)
(9)
(3)
(2)
(1)
This completes the setting for Communication Settings.
Create a screen with GT Designer3.
Extension interface
3rd stage
Com. unit name CH No. Driver name
5
(1) GT15-RS2-9P Barcode
2nd stage
Com. unit name CH No. Driver name
4
GT15-RS2-9P MELSERVO-J4,J3,J2S/M
(2)
1st stage
Com. unit name CH No. Driver name
1
(3) Bus(Q)
GT15-QBUS2
Standard interface 1
(only one connection)
Connection a controller
Com. unit name
CH No. Driver name
3
(7) OMRON THERMAC/INPANEL NEO
Standard interface 2
(only one connection)
Connection a controller
Com. unit name CH No.
Driver name
(8)
Connecting a barcode reader, RFID controller,
or personal computer
8
RFID
Standard interface 4
(only one connection)
Connection a controller (Without multi-channel Ethernet connection)
Com. unit name CH No.
Driver name
2
Ethernet (OMRON), Gateway
(9)
Connection a controller (With multi-channel Ethernet connection)
Com. unit name CH No. Driver name
Multi Multi-channel Ethernet connection
Com. unit name CH No. Driver name
21.3 GOT Side Settings
21
21 - 21