Mitsubishi Electric GOT2000 Series Connection Manual page 186

(b) Standby system (system B) PLC setting (GX Works3)
• Redundant Setting
System B IP Address
Control system IP address availability
B system module operation mode
Control system IP address availability
(4) GOT Side Settings
Set GT Designer3 as follows.
Setting item
Controller Type
Device setting (Network setting)
Ethernet setting
MELSEC Redundant Setting
(5) Monitoring target change when system switching occurs in a redundant system
When the system switching occurs, CPU (PLC station No.: 2) takes over the control of the Ethernet network system
as the control system.
The GOT automatically starts monitoring accroding to the specified system.
4 - 10
4.1 MELSEC iQ-R Series
Item
POINT POINT POINT
[Control system IP address availability] setting
Set [Control system IP address availability] to [Not use] (default).
If set to [Use], the GOT will not follow the system switching.
MELSEC iQ-R, RnMT/NC
Host
Other
Control
system/
standby
system
➠
5. ETHERNET CONNECTION
➠
4.3 MELSEC Redundant Setting
Set value
192.168.3.2
2
Online mode
Not Use
Contents of setting
Host (The control system is monitored.)
NW No.: Network No. of Ethernet
Station No.: Station number of the control system
The system (control system/standby system) of the the monitor target can
be speified.
Only when checking [Enable Redundant Function] in the following
[MELSEC Redundant System Setting], [Control System/Standby System]
can be set.
Model