Connecting To Built-In Ethernet Port Fxcpu (Fx3Ge) - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.13

Connecting to Built-in Ethernet port FXCPU (FX3GE)

This section describes the settings of the GOT and Ethernet module (FX Series) in the following case of the system
configuration.
■1. System configuration
*1 These setting items do not exist at the PLC side. However, the virtual values must be set on the GOT side.
➠
■2. Ethernet parameter settings of FX3GE
(1) Ethernet settings
Set the Ethernet parameter at [FX Parameter] on GX Works2.
To set FX3GE, GX Works2 Ver.1.91V or later is required.
For details on the setting of FX3GE, refer to the following manual.
➠ FX3GE SERIES PROGRAMMABLE CONTROLLERS HARDWARE MANUAL
Item
Channel
IP Address
Open Settings
POINT POINT POINT
FX3GE
For details of FX3GE, refer to the following manual.
➠ FX3GE SERIES PROGRAMMABLE CONTROLLERS HARDWARE MANUAL
<Ethernet module> (The settings other than the
following are set to the default)
Network No.
PC No.
IP address
Port No.
Communication
format
■4. [Controller Setting] and [Ethernet] of GT Designer3
<GOT>
(The settings other than the
following are set to the default)
PLC No. : 1
IP address : 192.168.0.18
Port No. : 5019
Communication : TCP (fixed)
format
*1
: 1 (virtual)
*1
: 2 (virtual)
: 192.168.0.19
: 5556 (fixed)
: TCP (fixed)
Setting
CH1
*1
192.168.1.250
Refer to (2).
5.4 PLC Side Setting
Setting
(with GOT connected)
5 - 89
5