Plc Side Setting When Connecting To Melsec/10 - Mitsubishi Electric GOT2000 Series Connection Manual

9.5

PLC side setting when connecting to MELSEC/10

MELSECNET/H network module
MELSECNET/10 network module
(QnA Series)
MELSECNET/10 network module
(A Series)
9.5.1 Connecting to MELSECNET/H network module
This section describes the settings of the GOT and MELSECNET/H network module in the following case of system
configuration.
When connecting the MELSECNET/H network module to the MELSECNET/10 network system, specify the MELSECNET/
10 Mode as a network type.
■1. System configuration
*1 The MELSECNET/H network module is mounted at slot 0 of the base unit.
The start I/O No. of the MELSECNET/H network module is set at "0".
Model name
POINT POINT POINT
MELSECNET/H network module
For details of the MELSECNET/H network module, refer to the following manual.
➠
Q corresponding MELSECNET/H Network System Reference Manual (PLC to PLC
network)
MELSECNET/10 (PLC to PLC network)
<MELSECNET/H network module> *1
(Use the default value for settings other than the following.)
Station No.
Mode
Network type
Network No.
Total stations
Network range assignment: LB0000
POINT POINT POINT
When connecting to Q170MCPU or Q170MSCPU(-S1)
When connected to Q170MCPU or Q170MSCPU(-S1), the start I/O No. of the MELSECNET/H
network module is set to "70".
9.5 PLC side setting when connecting to MELSEC/10
QJ71LP21, QJ71LP21-25, QJ71LP21S-25,
QJ71BR11
AJ71QLP21, AJ71QLP21S, AJ71QBR11,
A1SJ71QLP21, A1SJ71QLP21S, A1SJ71QBR11
AJ71LP21, AJ71BR11, A1SJ71LP21, A1SJ71BR1
<GOT> (Use the default value for settings other
than the following.)
LW0100 to LW01FF
H
: 1
: Online (10Mbps)
: MNET/10 mode (Control station)
: 1
: 2
to LB00FF
H H
LW0000 to LW00FF
H H
Reference
9.5.1
9.5.2
9.5.3
H
9 - 27
9