Connecting To C Controller Module (Melsec Iq-R Series) - Mitsubishi Electric GOT2000 Series Connection Manual

10.4.2

Connecting to C Controller module (MELSEC iQ-R Series)

This section describes the settings of the GOT and C Controller module (MELSEC iQ-R Series) in the following case of
system configuration.
Use CW Configurator for the C Controller module (MELSEC iQ-R Series) communication settings.
■1. System configuration1 (Network Type: CC IE Control)
*1
■2. System configuration1 (Network Type: CC IE Control extended mode)
*1
10 - 20
10.4 PLC Side Setting
CC-Link IE Controller Network module
<CC-Link IE Controller Network module>
(Use the default value for settings other than the following.)
The CC-Link IE Controller Network module is mounted on slot 0 of the base unit.
The start I/O No. of the CC-Link IE Controller Network module is set at [0].
CC-Link IE Controller Network
<CC-Link IE Controller Network module>
(Use the default value for settings other than the following.)
The CC-Link IE Controller Network module is mounted on slot 0 of the base unit.
The start I/O No. of the CC-Link IE Controller Network module is set at [0].
<GOT>
(Use the default value for settings other than
the following.)
*1
Station No. :1
Mode Setting :Online
Network type :CC IE Control (Control station)
Network No. :1
Total stations :2
Network range assignment :LB0000 to LB00FF
H
LW00000 to LW000FF
H
<GOT>
(Use the default value for settings other than
the following.)
*1
Station No. :1
Mode Setting :Online
Network type :CC IE Control extended mode
(Control station)
Network No. :1
Total stations :2
Network range assignment :LB0000 to LB00FF
H
LW00000 to LW000FF
H
H
H
H
H