Mitsubishi Electric GOT2000 Series Connection Manual page 663

(b) Link refresh setting
Item
Special relay (SB) refresh device
Special register (SW) refresh device
Remote input (RX) refresh device
Remote output (RY) refresh device
Remote register (RWr) refresh device
(c) CC-Link configuration setting
Item
Station type
*2
Expanded cyclic setting
*2
Exclusive station count
Remote station points
Reserve/invalid station select
Intelligent buffer select (word)
*1 When the [Mode] of the CC-Link module is set at [Remote net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
*1
Set value
-
-
Set as necessary.
: Necessary : As necessary
Set value
Ver.2 intelligent device station
(fixed)
Single
Exclusive station 1
32 points (fixed)
No setting
(Use default value)
: Necessary : As necessary
12.4 PLC Side Setting
Setting necessity at GOT
connection
: Not necessary
Setting necessity at GOT
connection
12
: Not necessary
12 - 21