(1) Setting of the CPU No.
(a)
When monitoring a single CPU system
Set to 0.
(b)
When monitoring a multiple CPU system
Set the CPU No. (0 to 4) in [CPU No.] when monitoring a multiple CPU system.
When [CPU No.] is set to "0", the monitoring target differs depending on the connection method.
• Direct CPU connection
• Bus connection
• Serial communication connection
• MELSECNET connection
• Ethernet connection
• CC-Link connection
(2) When monitoring link relay (B) and link register (W) assigned in link parameter and network
parameter.
Set the device link relay (B) and link register (W) running cyclic communication as [Host].
If it is set as [Other] in the network setting, the cyclic transmission is changed to the transient transmission regardless
of the network type, resulting in delay of the object display.
(3) Setting the device by inputting directly from the keyboard
When setting the device by inputting directly from the keyboard, set the items as follows.
(For devices except buffer memory(BM, G), motion controller, simple motion, SFC Block No.(BLS))
(For device BM and CPU No. 0)
Connection method
Device number
Head I/O number of buffer memory
Device name
Monitoring target
Connected PLC CPU
Control CPU
Bit condition
Device number
Device name
CPU No.
PLC station number
N/W No.
Channel No.
2
2 - 5