Access Range For Monitoring When Using Ethernet Connection - Mitsubishi Electric GOT2000 Series Connection Manual

3.2

Access Range for Monitoring when Using Ethernet Connection

■1. Access range
(1) MITSUBISHI ELECTRIC PLC
The PLC can be monitored via the Ethernet module set in the Ethernet setting on GT Designer3.
The GOT can access CPUs on another Ethernet, MELSECNET/H, MELSECNET/10, CC-Link IE Controller Network,
or CC-Link field network via the RCPU, R Motion (Ver.03 or later), QCPU or QnACPU (When monitoring other
networks via the R Motion (Ver.03 or later), Ethernet is possible only.).
However, the GOT cannot monitor the CNC C70 on other networks.
(The GOT cannot monitor the AnNCPU on the CC-Link IE Controller Network, MELSECNET/H, and MELSECNET/
10 networks)
For monitoring CPUs on the MELSECNET/H, MELSECNET/10, CC-Link IE Controller Network, and CC-Link field
network, set the routing parameter.
For the routing parameter setting, refer to the following manuals.
• Routing parameter setting of the GOT
➠
• Routing parameter setting for accessing CPUs on the MELSECNET/H network system, or MELSECNET/10
network system
➠
• Routing parameter setting for accessing CPUs on the CC-Link IE Controller Network
➠
• Routing parameter setting for accessing CPUs on the CC-Link IE Field Network
➠
Monitoring via the MELSECNET (II) or MELSECNET/B network cannot be performed.
■2. Various settings
For the Ethernet setting by GT Designer3, refer to the following.
➠
3 - 14
3.2 Access Range for Monitoring when Using Ethernet Connection
5. ETHERNET CONNECTION
Q corresponding MELSECNET/H Network System Reference Manual (PLC to PLC network)
CC-Link IE Controller Network Reference Manual
MELSEC-Q CC-Link IE Field Network Master/Local Module User's Manual
CC-Link IE Field Network Ethernet Adapter Module User's Manual
GOT
MELSECNET/H etc.
POINT POINT POINT
(1) Host in the Ethernet connection
While the GOT is handled as the host in MELSECNET/H, MELSECNET/10 or CC-Link
connection, the station (Ethernet module) set as the host in the Ethernet setting of GT
Designer3 is handled as the host in Ethernet connection.
(2) Precautions when using the QCPU redundant system
When monitoring other networks, do not set the QCPU redundant system as a relay station.
If the QCPU redundant system is set as a relay station, the GOT cannot switch the
monitoring target automatically when the system is switched.
(A timeout error occurs due to failed monitoring)
5. ETHERNET CONNECTION
Hub etc.
Gateway
(Router etc.)