Mitsubishi Electric GOT2000 Series Connection Manual page 316

■3. [Controller Setting] and [Ethernet] of GT Designer3
(1) Controller setting
GOT Net No.
GOT Station
GOT Standard Ethernet Setting
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
(2) GOT Standard Ethernet Setting
GOT IP Address
Subnet Mask
Default Gateway
Peripheral Communication Port No.
Transparent Port No.
(3) Ethernet setting
Ethernet setting No.1
*1
*2
5 - 50
5.4 PLC Side Setting
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠
5.3.1 Setting communication interface (Controller Setting)
(2) Ethernet setting
When connecting Built-in Ethernet port CPU to a GOT, the setting items for the network No.
and station No. do not exist at the PLC side. However, these virtual values must be set on the
GOT side. Therefore, set the network No. and station No.
Set the network No. that does not exist on the network system and any station No.
Item
Item
Item
Host
N/W No.
PLC No.
Type
IP Address
Port No.
Communication
Set the same value as that of GOT N/W No.
Set a value different from that of the GOT PLC No. and the PLC No. of other PLCs on the same network.
Set value (Use default value)
1
1
192.168.3.18
5001
3times
3sec
3sec
0ms
Set value (Use default value)
192.168.3.18
255.255.255.0
0.0.0.0
5015
5014
Set value
*
*1
1
*2
2
FX5CPU
192.168.3.250
5562 (fixed)
TCP (fixed)