GE LOGIQ E9 Service Manual page 92

GE H
EALTHCARE
D 5180263-100, R
IRECTION
3-6-5 Connections on the Patient I/O panel
3-6-5-1 Connect ECG
Refer to Chapter 10 in the Basic User Manual for more information.
3-6-6 Connecting Probes
3-6-6-1 Introduction to Connecting Probes
Probes can be connected at any time, whether the unit is on or off.
R3.x and earlier LOGIQ E9s have two types of probe ports: one non-DLP probe port and three DLP
probe ports (Figure 3-10). R4.x LOGIQ E9s have one type of probe ports: four DLP probe ports (Figure
3-9).
The non-DLP probe port is compatible with the S1-5, S4-10, 6Tc (TEE probe), and 3CRF probe
connectors.
The three DLP probe ports are specific to the LOGIQ E9 probe connectors.
Figure 3-9 Probe connectors - (1) Non-DLP and (2) DLP Probe Port - R3.x and earlier
R4.x and later LOGIQ E9s have one type of probe ports: four DLP probe ports (Figure 3-10).
Figure 3-10 Probe connectors, four DLP Probe Ports - R4.x
3 - 20
5
EV
1
Section 3-6 - Completing the setup
LOGIQ E9 Service Manual
2