GE LOGIQ E9 Service Manual page 376
Hide thumbs
Also See for LOGIQ E9:
- Service manual (808 pages) ,
- User manual (256 pages) ,
- Technical publication (127 pages)
Advertisement
GE H
EALTHCARE
D
5180263-100, R
IRECTION
8-4-6-5
System Software Load (cont'd)
5.) Perform a Backup from the Utility -> System -> Backup/Restore page. You should back up the
Patient Archive images, Report Archive, User-Defined Configuration (Customer Presets), and
Service settings. You will perform a Restore after the install.
For a full Base load, this step is mandatory.
For a C: Partition load, this step is precautionary in the event the software load has issues. The data
should transfer over for a C: Partition load.
See: the latest revision of the LOGIQ E9 Basic User Manual, Chapter 3.
6.) Confirm with customer that all patient data has been archived. If not, perform the archive.
7.) Insert the applicable LOGIQ E9 System Software disk into the DVD drive.
8.) Properly power down the System. Depress the ON switch and select "Shutdown" on the window.
9.) Wait until the LCDs on the Operator Panel are switched off and the ON switch has turned amber.
10.)Power ON the System.
The scanner boots from the Software disk and displays a load warning message.
****WARNING * WARNING * WARNING * WARNING * WARNING * WARNING ****
THIS PROCEDURE MAY RESULT IN COMPLETE PATIENT DATA LOSS IF NOT USED CORRECTLY! PLEASE READ
THE OPTIONS BELOW CAREFULLY BEFORE PROCEEDING.
This process is NOT REVERSIBLE and should NOT be stopped once started! DO NOT power off the
system until the process has completed. It will take less than 10 minutes to load the drive.
If this process is stopped for some reason, you will have to run it again to completion or
else the system will not work.
If you want to proceed with this process press the "Enter" key to continue with option
selection.
...or...
Remove the disk from the Optical drive and Press "CTRL-C" now to exit and power cycle your
system to restart it without overwriting your disk drive's current contents.
Press any key to continue...
8 - 12
5
EV
Figure 8-2 System Software load warning message
Section 8-4 - Loading / Reloading / Upgrading the Software
LOGIQ E9 Service Manual
Advertisement
