GE LOGIQ E9 Service Manual page 585

Hide thumbs Also See for LOGIQ E9:

5180263-100, R

Assembling or replacing the On-Board V Nav Stand

For reference of assembly, parts location and parts identification, see:

Table 8-109 "Reference for assembling Option to LOGIQ E9" on page

Remove Grounding Plug (center) and the

Rear Cover mounting screws.

Install the V NAV Stand Post Stand-off

Fasteners (7a-7c) to Targa, short in the

bottom and long in the top. Tighten

NOTE: The Rear Cover mounting flange

should not get pinched by the Stand-off

Fasteners. Two of the Stand-off Fasteners

will fit in the holes in the cover and hold the

cover in place after they are installed.

Table 8-110 Option Installation to LOGIQ E9

Chapter 8 Replacement procedures

LOGIQ E9 Service Manual

Corresponding Graphic