GE LOGIQ E9 Service Manual page 489

GE H
EALTHCARE
D 5180263-100, R
IRECTION
8-8-1-5 Rear Casters installation
1.) Loose the bolt before putting on the ramp.
2.) Align the Caster, mounting it flat and toward the back.
3.) Position the Caster so it align with the hole for the fixing bolt.
4.) Install the fixing bolt (M12 X 40 mm). Use a 10 mm HEX key, torque: 81 Nm (59.7 lbf-ft).
5.) Remove the Wooden Wedge.
6.) Roll the system off the Bevel Edged Board.
7.) To replace the other Rear Caster, repeat all the steps, starting from
on page 8-124,
the system.
8.) Install the Rear Cover.
9.) Install the Rear Bumper.
10.)Install the Side Covers.
5
EV
but now using the Bevel Edged board and the Wooden Wedge on the other side of
Chapter 8 Replacement procedures
LOGIQ E9 Service Manual
8-8-1-4 "Rear Casters removal"
8 - 125