GE LOGIQ E9 Service Manual page 408

GE H
EALTHCARE
D 5180263-100, R
IRECTION
8-5-9 Rear Bumper replacement
8-5-9-1 Manpower
One person, 15 minutes.
8-5-9-2 Tools
For tools needed, refer to:
8-5-9-3 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the system
2.) Disconnect the mains power cable from the wall outlet.
3.) Disconnect all Probes and External I/O Cabling.
4.) Remove Side Covers.
5.) Remove Rear Cover.
Follow these links if you need more information:
• 4-2-4 "Power shut down" on page 4-7.
• 8-5-2 "Side Covers replacement" on page 8-27.
• 8-5-7 "Rear Cover replacement" on page 8-38.
8-5-9-4 Rear Bumper removal
1.) Remove the two screws securing the Rear Bumper.
2.) Remove Bumper.
8-5-9-5 Rear Bumper installation
1.) Place the Rear Bumper into position
2.) Install the two screws to secure the Rear Bumper.
8 - 44
5
EV
8-2-5 "Tools needed for servicing LOGIQ E9" on page
Figure 8-30 Left screw placement for Rear Bumper
Section 8-5 - Replacing Covers and Bumpers
LOGIQ E9 Service Manual
8-5.