GE LOGIQ E9 Service Manual page 570

GE H
EALTHCARE
D 5180263-100, R
IRECTION
8-11-7-4 Printer Bracket removal
1.) Raise the console height to the highest level.
2.) Unlatch the two latches (1) that clamp the printer bracket to the top of the BEP (2).
3.) Tilt the Main Console Front Cover forward just until the lower Column Cover stop tabs (3) clear.
4.) Lift the Column Cover Assembly.
5.) Push the printer bracket toward the Card Cage approximately 1/2 inch to free the three tabs (4) from
the BEP.
6.) Remove the printer bracket from the BEP.
8-11-7-5 Printer Bracket installation
1.) Position the printer bracket at the top of the BEP.
Be sure the lip, on the underside of the bracket, hooks on the edge of the card rack, and the three
tabs insert into the slots on the top of the BEP frame. The lip "clamps" the card rack and BEP
together. This is a tight fit.
2.) Lower the lower Column Cover.
3.) Position the Main Console Front Cover to engage the lower Column Cover stop tabs.
4.) Latch the two latches that clamp the printer bracket to the top of the BEP.
5.) Slide the Black and White printer into the printer bracket and connect the cables to the back of the
printer.
6.) Tighten the printer bracket wing nut to secure the printer.
7.) Connect the printer cables.
8.) Replace the covers.
8 - 206
5
EV
Figure 8-60 Printer Bracket
Section 8-11 - Peripherals replacement
LOGIQ E9 Service Manual