GE LOGIQ E9 Service Manual page 387

GE H
EALTHCARE
D 5180263-100, R
IRECTION
8-4-7 Loading the Application Software Only (cont'd)
After the reboot, the Start Application window displays.
6.) Remove the LOGIQ E9 Applications Software DVD from the DVD drive.
7.) Store the application disks with the system.
8.) Remove and destroy the previous Application software version disks.
Figure 8-17 Start Application window (window will reflect actual software version
9.) From the Start Application window, select "Start."
The first time the application loads after a SW reload, you may see: the error shown in Figure 8-29,
"SW Reload Error Message." Select OK and reboot the system.
During the reboot process, the system may prompt for the Basic Option string (valid license) (see:
Figure 8-19 "Enter Option String" on page
If the Basic Option string is not saved in the Option Dongle, or if this is a software upgrade, the SW
License window may open.
NOTE: If only the title bar is visible in the lower, left corner of the monitor, double-click the SW License
title bar to expand the window.
5
EV
instead of "Rx.x.x")
Figure 8-18 SW Reload Error Message
Chapter 8 Replacement procedures
8-24.
LOGIQ E9 Service Manual
8 - 23