GE LOGIQ E9 Service Manual page 508

GE H
EALTHCARE
D 5180263-100, R
IRECTION
Table 8-60
5. Reach inside the BEP and connect the
BEP cable to the Backplane J2 (left) on a
MRX Configuration.
MAKE sure the BEP Cable to the
Backplane for BEP6 is installed as shown.
DO NOT twist.
Or, the Backplane cable, J3 (right) and J5
PCIe to the Card Rack on a GFI
Configuration, using a BEP6.
6.
NOTE: If you DO NOT reconnect the internal BEP cable to the Backplane, the system will power
up but WILL NOT scan or WILL LAUNCH into simulator mode.
7.
Insert the bottom lip of the BEP cover inside the base of the BEP.
8.
Connect the battery cable to PCN1 and the CB to PB cable to PCN2 on the CB. Make sure the
cable connectors are "locked" into place on the CB connections.
9.
MAKE SURE all cables are clear of the BEP Cover and tilt the top of the BEP cover toward the
BEP.
Be careful not to pinch any of the cables when installing the BEP cover.
10. Tighten and secure the thumb screws or screws at the top of the BEP cover, or the three screws
that attach the cover to the BEP.
8 - 144
5
EV
BEP installation
Steps
NOTICE
Section 8-9 - BEP (Back End Processor) parts replacement
Corresponding Graphic
BEP Cable to MRX Backplane, J2
BEP Cable to Backplane J3 of GFI Configuration
(view inside the BEP)
LOGIQ E9 Service Manual