GE LOGIQ E9 Service Manual page 567

GE H
EALTHCARE
D 5180263-100, R
IRECTION
8-11-6 Digital Graphic Printer replacement
8-11-6-1 Manpower
One person, 15 minutes.
8-11-6-2 Tools
For tools needed, refer to:
8-11-6-3 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the system.
2.) Disconnect the mains power cable from the wall outlet.
3.) Disconnect all Probes.
4.) Remove the Left Side Cover.
Follow these links if you need more information:
• 4-2-4 "Power shut down" on page 4-7.
• 8-5-2 "Side Covers replacement" on page 8-27.
8-11-6-4 Black and White Digital Graphic Printer removal
1.) Disconnect the cables from the back of the printer.
2.) Loosen the printer bracket wing nut that secures the printer.
3.) Slide the printer out.
8-11-6-5 Black and White Digital Graphic Printer installation
1.) Slide the printer into the printer bracket until the face is flush with the system.
2.) Tighten the printer bracket wing nut to secure the printer in the printer bracket.
3.) Connect the cables to the back of the printer.
4.) Replace the Left Side Cover.
5
EV
8-2-5 "Tools needed for servicing LOGIQ E9" on page
Figure 8-59 Black and White Digital Graphic Printer - wing nut
Chapter 8 Replacement procedures
LOGIQ E9 Service Manual
8-5.
8 - 203