Use The Reinitialization Tool To Clear The Database And Upload Software (Unix) - Cisco ONS 15454 Troubleshooting Manual

1.6.2 Restore the Node to Factory Configuration
Note
In the Search Path field, verify that the path to the CISCO15454 folder on the CD drive is listed.
Step 10
Caution Before you perform the next step, be sure you are uploading the correct database. You cannot reverse the
upload process after you click Yes.
Step 11 Click Go. A confirmation dialog box appears.
Step 12 Click Yes.
Step 13 The status bar at the bottom of the screen displays Complete when the node has activated the software
and uploaded the database.
Note
Step 14 If you are logged into CTC, close the browser window and disconnect the straight-through LAN cable
from the RJ-45 (LAN) port on the TCC2 card or on the hub or switch to which the ONS 15454 is
physically connected. Reconnect your straight-through LAN cable to the LAN port and log back into
CTC.
Manually set the node name and network configuration to site-specific values. See the Cisco ONS 15454
Step 15
Procedure Guide for information about setting the node name, IP address, mask and gateway, and IIOP
port.

Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX)

Restoring a node to the factory configuration deletes all cross-connects on the node.
Caution
Restoring a node to factory configuration on a UNIX workstation should only be carried out on a standby
Caution
TCC2 card.
The TCC2 cards reboot several times during this procedure. Wait until they are completely rebooted
Note
before continuing.
Note Java Runtime Environment (JRE) 1.03_02 must also be installed on the computer you use to perform
this procedure.
Step 1 Insert the system software CD containing the reinit tool, software, and defaults database into the
computer CD-ROM drive. If the CTC Installation Wizard appears, click Cancel.
Cisco ONS 15454 Troubleshooting Guide, R4.6
1-64
The Force Upload box is only applicable when the Upload Package checkbox is checked.
The Complete message only indicates that the TCC2 successfully uploaded the database, not that
the database restore was successful. The TCC2 then tries to restore the database after it reboots.
Chapter 1 General Troubleshooting
November 2004