Shared Packet Ring Ethernet Circuits; Figure 9-10 Selecting Vlans - Cisco ONS 15327 User Documentation

Chapter 9 Ethernet Operation
d.
e.

Figure 9-10 Selecting VLANs

Click Next.
Step 19
The Circuit Creation (Circuit Routing Preferences) dialog box appears.
Step 20 Confirm that the following information about the point-to-point circuit is correct:
•
•
•
•
•
Click Finish.
Step 21
Step 22 You now need to provision the Ethernet ports and assign ports to VLANs. For port provisioning
instructions, see the
assigning ports to VLANs, see the
page
Cross-Connects" section on page

9.4.2 Shared Packet Ring Ethernet Circuits

This section provides steps for creating a shared packet ring
may differ from the example.
June 2002
The VLAN ID should be the next available number between 2 and 4093 that is not already
Note
assigned to an existing VLAN. Each ONS 15327 network supports a maximum of 509
user-provisionable VLANs.
Click OK.
Highlight the VLAN name and click the >> button to move the available VLAN to the Circuit
VLANs column (Figure 9-10).
Circuit name
Circuit type
Circuit size
VLANs on the circuit
ONS 15327 nodes included in the circuit
"Provision E10/100-4 Ethernet Ports" procedure on page
9-25. For information about manually provisioning circuits, see the
"Provision Ethernet Ports for VLAN Membership" procedure on
9-16.
Cisco ONS 15327 User Documentation, R3.3
Ethernet Circuit Configurations
9-3. For instructions about
"Ethernet Manual
(Figure 9-11). Your network architecture
9-9